在白沙酒店晚上怎么叫服务

Welcome to Shanghai Luoying pipeline equipment Co., Ltd Official website! For details, please call 021-6221-2627

Production and processing of Luoying pipeline with flexible rubber joint for pump

Time: 03-10 󰃯 Reading times: 249 󰃳 Editor in charge: The sea 󰃗 Column: product focus

Introduction: The rubber pump can be manufactured by Shanghai rubber pump factory

Flexible pump Rubber joint Generally installed in the import and export trade connection area of the pump Flexible rubber joint It is manufactured by Shanghai Luoying pipeline factory. The products are: rubber joint for pump and pump Rubber flexible joint , rubber products for pumps, stainless steel clamps for pumps, rubber malleable connectors for pumps. The flexible rubber joint for pump made by our company consists of inner surface rubber, cloth curtain layer and steel ring, which is formed by vulcanized rubber and then combined with metal material flange or parallel face joint looper flange. Products with high internal relative density, high working pressure and good ductility. It is widely used in all kinds of pipeline system software.
Common problems in installation of flexible rubber joint for pump:
1. The appropriate model and specification shall be selected according to the pressure, interface mode, material and compensation amount of the pipeline, and the total number shall be selected according to the provisions of noise and noise reduction deviation.
2. When the flexible rubber joint is used in the import and export trade of centrifugal pump, it should be located at the side near the centrifugal pump, and the metal material reducing joint should be installed in the middle of the centrifugal pump, and it should be installed at the large size of the variable diameter.
3. For the water supply and drainage of high-rise residential buildings or suspended in the air, the pipeline pump should be fixed on the support, fixed support or anchor frame, and the connector should not bear the net weight and radial force of the pipe itself, otherwise the connector should be equipped with anti pulling equipment (its bearing capacity needs to exceed the radial force of the pipeline).
4. When installing the rubber joint, the screw of the bolt should extend to both sides of the connector, and the bolt of each flange inner hole should be continuously and evenly tightened according to the top angle charging method to avoid pressure deviation. Standard wrench shall be used to tighten the threaded joint evenly, and the point adding rod shall not be used to add points to make the movable joint slip, slip edge and fracture, and regular maintenance shall be carried out to prevent looseness leading to disc detachment or leakage.
5. After the rubber joint is subjected to pressure for the first time (such as installation of hydraulic test), or before it is stopped for a long time, the bolts shall be re pressurized and tightened before putting into operation.
6. The application or storage of rubber joint should prevent high temperature, ozone, oil and acid-base environment. Sunshade frame shall be built for outdoor or sunny and windward pipes. Exposure to the sun, rain and wind erosion are prohibited. It is forbidden to brush paint and coil thermal insulation materials on the surface of connector. Due to the aging of rubber products.