在白沙酒店晚上怎么叫服务

021-6221-2627

What should be paid attention to in field cutting and welding of rigid waterproof casing

Time: 04-14 󰃯 Reading times: 945 󰃳 Editor in charge: The sea 󰃗 Column: product focus

Introduction: In daily life, many people may have some understanding of the waterproof casing, but the waterproof sleeve is also divided into two different waterproof casings according to its use function. The following is to introduce the rigid waterproof casing which is often used in daily life. Rigid waterproof sleeve

In daily life, a lot of people are Waterproof casing There may be some understanding, but the waterproof casing is also divided into two different types according to its use function. The following will introduce the common used in daily life Rigid waterproof casing Rigid waterproof casing, also known as: steel casing. In order to prevent water from leaking out of the side wall of the pool, the water pipes passing through the pool are required to be installed with waterproof casing, which is divided into two types: rigid and flexible. After installation, if deformation is allowed, it is called flexibility; if deformation is not allowed, it is called rigidity.
Rigid waterproof casing in the pipeline production or after the sale of installation, due to the diversity of terrain. In order to better adapt to the terrain and make the function of waterproof casing play a strong role, the commonly used method of waterproof casing cutting. We should also master the operation skills of pipe cutting in the construction of waterproof casing. A set of notes for the construction personnel of the first line of casing cutting should be helpful for the construction personnel. The following information is the waterproof pipe cutting should pay attention to the aspects.
1. There are two ways to cut the waterproof casing material pipe, namely, mechanical cutting and oxyacetylene flame cutting, according to the requirements of construction specifications.
2. The carbon steel pipe with waterproof sleeve should be cut by mechanical method. When using oxyacetylene flame cutting, it is necessary to ensure the correct size and smooth surface.
3. The quality of pipe incision shall meet the following requirements.
4. The surface of the incision should be flat and free of cracks, double skin, burr, convex concave, shrinkage, slag, oxide, iron filings, etc.
5. The inclination deviation of the end face of the incision shall not be greater than 1% of the outer diameter of the pipe and shall not exceed 3 mm.
According to the above notes, I believe you also have a relative understanding of cutting or welding in the field. In this small part, I suggest that when cutting or welding according to the field, we hope you can read the above precautions first.